Moldflow Ideas

Anonymous · ‎08-06-2019

In the flow analysis results, there is a result called "Grow from". But go futher on this, please show the weight and persentage of resin injected per gate of resin filled in the cavity.

csegard · ‎06-24-2016

Hello, actually, Moldflow Insight offer the possibility to have a flatness and roundness result by using macros. You have to select nodes and run the macros. It could be interesting to have this include in the customized results. And by selecting faces or mesh, it could use the command expand to directly select nodes on that. This result could be also interesting by just asking on a surface. regards Cédric

csegard · ‎06-24-2016

Hello, During warp analysis, it could be interesting to be able to set up critical dimensions and having results on that point directly. It is present in Shrink analysis but then no more use. Best regards Cédric

csegard · ‎06-24-2016

hello, It would interesting to have the possibility to create nodes on specific features, like center of circle or middle of arc and to be able to have a warpage result on these points. regards Cédric

csegard · ‎06-24-2016

hello, For warpage analysis, it could be interesting to have a result showing the evolution of a path made by nodes to know the evolution of shrinkage on that path. instead of looking at the dimension of the extremity of that curves that may give errors, this result could allow to see the defect of bending on 1 area. Thanks Best regards Cédric

Community

Show the weight and percentage of resin injected per gate.

flatness and roundness results having an easier way to use

use of critical dimension of boundary conditions for Warp analysis

warpage analysis on particular points

results to have a variation of length on a path

Forums Links