When adding manual nc like a comment, action or a stop in HSMWorks, I place the manual nc where I would like it either before or after a certain operation. However when posted out, the manual nc gets posted within the operation just before the last few lines of code in that operation. I then have to manually re-arrange the post code and line numbering using hsm editor every time. This has happened on all versions of HSMWorks and all versions of post processors. Please see attached photos. The Tailstock M21 is just one of a few custom actions I have made however the issue still applies to all other actions, stops, comments that are built into hsmworks/post processor. The stop photo is a good example. The stop gets posted before the code has told the machine to go home, ideally we want the machine to finish its operation completely and then stop. From my understanding this will require a bit of work by Autodesk on their generic posts. I think it would be a great idea if Autodesk implemented this as a standard for their generic posts
Show More