Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Submitted byAnonymouson01-15-201901:42 AM
Status:
Gathering Support
Show Disconnects in current view only
I would like to be able to show disconnected pipes/ducts on my current view rather than turning it on overall. If I turn it on on a view and then switch to another view that shows a lot of elements, showing disconnects can overwhelm the view and I have to turn it off again. And it takes an insane amount of time of large projects.
Thanks for logging this request.. while we haven't addressed the specific request related to view specific disconnect marker settings, there was an improvement in 2021.1 to reduce the amount of time it takes to toggle on/off disconnects, in some cases quite significantly, which may alleviate some of pain point here. We will leave this request open for consideration.
