Hi,
im trying to model arc slab on arc wall with arc discritizaton, but the joints are not connected to each other.
and also it give two joints at the same position
so what might be the problem ?
Hi @risefire12 ,
You have a different discretization for arc segments:
Please check this topic.
Do you find the posts helpful? "LIKE" these posts!
Have your question been answered successfully? Click 'ACCEPT SOLUTION' button.
Roman Zhelezniak
Robot Evangelist & Passionate Civil Structural Engineer
Hi,
thank you very much for your reply.
i did set the discretization for floor to 7 same as the wall.. but still same problem
hi @risefire12
same workaround, split the circular edge into multiple arcs of the same radius and redo the vertical panels
Best regards
hi @risefire12
below, Split Arcs, a program to split all arcs of a contour, polyline, arc.
this program cuts each arc to the maximum length including if checked, the selected nodes. (see this short demo)
Best regards
Released 26/09/2024
Hi ,
added to the list:
Can't find what you're looking for? Ask the community or share your knowledge.