Created a WC carrier family with embedded families. I started with a new clean family, Embedded the 3x3 angle built my frame. Then imported the 1-5/8" uni-strut for the bracing and the pipe racks. I load this family into a project to create an assembly view for the fab shop to build. HOWEVER when I create the assembly views the 3x3 angle disappears from my assembly views but stays in view in my plan view. I have moved the assembly origin point to different points in my view and they still don't show up. Any help would be greatly appreciated.
Solved! Go to Solution.
Solved by ToanDN. Go to Solution.
Check:
- Try setting 3D Assembly View to Fine Detail Level
- See if 3x3 angle family has any visibility parameters--i.e. Show in Plan/RCP, 3D, etc
Sam question, different forums.
https://forums.autodesk.com/t5/revit-mep-forum/assembly-views/m-p/7948182#M51457
Can't find what you're looking for? Ask the community or share your knowledge.