No Hatch lines when I use Half Section View Under View Tab in Inventor Part Mode

[Gurpreet.Badwall]

Hi Inventor Experts,

I am not sure if this is the case with Inventor. When I use Half Section View command under View Tab in Part Mode, Inventor is not showing the Section Hatch Lines. Please have a look on the attached Inventor Part File and  Screenshots. It does show the Half Section View but without the Hatch Lines.

NOTE: Just letting you know , I am not talking about the Half Section View in Drawing Mode. 

Inventor Version Used: Inventor Professional 2021.3.1

Regards

Gurpreet   

[bradeneuropeArthur · Accepted solution]

That is normal behavior!

[Gurpreet.Badwall]

@bradeneuropeArthur  Thanks a lot Dear for your quick response. 

I am also Fusion 360 user  and its showing the Hatch Line in Part Mode when I use the Half Section View command. 

[bradeneuropeArthur]

Would be a good thing for the Idea Station, I would vote it!

[johnsonshiue]

Hi! Do you want to see the 2D hatch pattern in 3D model? I don't think it is supported. The closest thing I can think of is to create shaded section view in the drawing.

Many thanks!

[Gurpreet.Badwall]

@johnsonshiue Thanks a lot for your reply. Just letting you know I am also a Fusion 360 user and it does offer the Hatch Lines in Part Mode when I use the Half section view. 

Note: I  already have hatch lines when I create the Section view in Drawing mode in Inventor.