Isolate part from part

[labrakis6JLPE]

Hello guys!

Here is what i would like to do. From a part file i want to isolate one solid body and save it in another part file.

How can this be done?

Thank you!

[labrakis6JLPE]

Hello guys!

Here is what i would like to do. From a part file i want to isolate one solid body and save it in another part file.

How can this be done?

Thank you!

[Gabriel_Watson · Accepted solution]

Make part command?
https://knowledge.autodesk.com/support/inventor/troubleshooting/caas/sfdcarticles/sfdcarticles/How-t...

If your other part already exists, you may try instead the derive command on the other part, then select only the solids you need.

[Gabriel_Watson · Accepted solution]

Make part command?
https://knowledge.autodesk.com/support/inventor/troubleshooting/caas/sfdcarticles/sfdcarticles/How-t...

If your other part already exists, you may try instead the derive command on the other part, then select only the solids you need.

[JDMather · Accepted solution]

Manage tab> Make Part.

Attach your file here if you can't figure it out.

[JDMather · Accepted solution]

Manage tab> Make Part.

Attach your file here if you can't figure it out.

[labrakis6JLPE]

Thank you so much!! I did it!!

[labrakis6JLPE]

Thank you so much!! I did it!!

[labrakis6JLPE]

That was it!

[labrakis6JLPE]

That was it!