dear all,
i have a task to convert a frame generator part from solid works part to inventor
i have a solid works part , i facing to configure in inventor as similar to solid works part 
HOW TO USE iPART and iassembly for frame generator to configured frame assembly
So are you considering this as your frame skeleton that will be inserted into an assembly and then frame members are added?
If you're actually using Inventor Frame Generator it can't be based on an iassembly Each model must be separate.
Mark Lancaster
& Autodesk Services MarketPlace Provider
Autodesk Inventor Certified Professional & not an Autodesk Employee
Likes is much appreciated if the information I have shared is helpful to you and/or others
Did this resolve your issue? Please accept it "As a Solution" so others may benefit from it.
Mark is correct. The problem is, the way FG works is it uses a part sketch to create the frame members, miters and trims. If you try and remove any part of it through iassemblies, the whole FG assembly will fail. The closest you can come to what you are describing is to have the complete FG assembly turned on or off in an upper level assembly.
Windows 10 x64 -16GB Ram
Intel i7-6700 @ 3.41ghz
nVidia GTS 250 - 1 GB
Inventor Pro 2018
Three separate FG models. That is the safest best method. FG is a great tool, but it can be complicated. Especially when it comes to the naming of the components and folder structure.
Windows 10 x64 -16GB Ram
Intel i7-6700 @ 3.41ghz
nVidia GTS 250 - 1 GB
Inventor Pro 2018
