Hello,
I need to draw a lubrication groove, i paste drawing design what i've got below with fusion design what i draw. Can anyone help with this? Thank you very much in advance for any help.
Solved! Go to Solution.
Solved by davebYYPCU. Go to Solution.
Solved by MRWakefield. Go to Solution.
You need to create an angled plane for the groove section profile then create a revolve cut. Take a look at the attached model to see how I did it.
If this answers your question please mark the thread as solved as it can help others find solutions in the future.
Marcus Wakefield
Yep, Plane on Angle - X Axis, - minus 30 degrees. Put a sketch on it.
Then Project > Project curved wall. Path is actually a circle, coincident to the Projected arc.
Pipe > Cut on the circle.
Might help....
Can't find what you're looking for? Ask the community or share your knowledge.