How to design a lubrication groove

[jambrozy]

Hello, 

I need to draw a lubrication groove, i paste drawing design what i've got below with fusion design what i draw. Can anyone help with this? Thank you very much in advance for any help.

 

[MRWakefield · Accepted solution]

You need to create an angled plane for the groove section profile then create a revolve cut. Take a look at the attached model to see how I did it.

[jambrozy]

Holy ****, amazing ... I never drawing something like this, thank you ! 🙂

[davebYYPCU · Accepted solution]

Yep, Plane on Angle - X Axis, - minus 30 degrees.  Put a sketch on it.

Then Project > Project curved wall.  Path is actually a circle, coincident to the Projected arc.

Pipe > Cut on the circle.

Might help....