CID 8 is set as an rectangular / round fitting, as are all of the square to round fittings. It would be greatly beneficial if you could add a square to round itm what only looked at the round spec table.    Our shop welds all square to rounds 26" in diameter and up. Our round specs are set accordingly. We weld 18ga and thicker. Rectangular tables are typically set up calling out 18ga much higher than round tables. Therefore, we have a welded collar, but the body is not. Currently scripting it on the CAM side to fix the issue.    This could all be solved, along with many other issues we could have a Alternate Material set-up or a Square to round ITM what only looks at the round spec table.   Be sure to kudo! Show More