Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Dean, I think you're snapping to the inside of the 3DSOLID cylinder that is very nearly on top of the circle. Try snapping to the same circle at the bottom where there's a gap in the cylinder.
I do not know about 2018 but on 2017 I get the same behavior as 2015. See Screencast for both, 2015 and 2017 versions. Also looking at co-ordinates in status bar in Post 14 screenshot, it seems like it's reading the modelspace co-ordinates.
