cant trim in 3d

[Anonymous]

hi

 i cant trim the middle frames to the top frame in the drawing ???

[Anonymous]

hi

 i cant trim the middle frames to the top frame in the drawing ???

[john.vellek]

Hi @Anonymous,

If I were doing this I would likely use SLICE to trim off the top of the vertical members.  Give it a try and let me know if you have luck or get stuck.

You could also grip select the ends of the verticals and drag them down.

Please select the Accept as Solution button if my post solves your issue or answers your question.

[john.vellek]

Hi @Anonymous,

If I were doing this I would likely use SLICE to trim off the top of the vertical members.  Give it a try and let me know if you have luck or get stuck.

You could also grip select the ends of the verticals and drag them down.

Please select the Accept as Solution button if my post solves your issue or answers your question.

[Anonymous]

i tried dragging grips but it pulls the hieght of the whole frome not each corner cant seen to slice it ?

[Anonymous]

i tried dragging grips but it pulls the hieght of the whole frome not each corner cant seen to slice it ?

[Alfred.NESWADBA · Accepted solution]

Hi,

please find this video which shows how to change the middle objects and UNION them at the end.

- alfred -

[Alfred.NESWADBA · Accepted solution]

Hi,

please find this video which shows how to change the middle objects and UNION them at the end.

- alfred -

[Anonymous]

this is great thank you also how can i cut the top frame back where it overhangs the low end 

tegards

ian 

thank you

[Anonymous]

this is great thank you also how can i cut the top frame back where it overhangs the low end 

tegards

ian 

thank you

[Alfred.NESWADBA · Accepted solution]

Hi,

you have got the tip with command _SLICE from @john.vellek already 😉

- alfred -

[Alfred.NESWADBA · Accepted solution]

Hi,

you have got the tip with command _SLICE from @john.vellek already 😉

- alfred -

[yangguoshe]

You can also use the presspull command

[yangguoshe]

You can also use the presspull command