Precast reinforcement not working

[kari_rinne]

I am trying to add reinforcement with precast to the wall I already split previously. However when I do it it just tells me that an error happened and I should report the issue. What should I do?

[jay_colcombe]

This is old fix but it could still be relevant;

Workaround:
Turn off Precast before making any modifications

"An error was encountered while trying to update the Precast Elements" in Revit (autodesk.com)

[kari_rinne]

It doesn't seem to change anything unfortunately. I did it but I still get the same error message

[jay_colcombe]

I would assume it is related to the Panel with the opening?

Can you create the opening a different way such as the Structural Opening Tool or splitting then Editing the Assembly with the opening.

can you share the model for checking?

[podaruc]

Hi  kari_rinne,

I would like to investigate this issue. For this, I need to take a  look at the project where this occurs. You can attach the file here, or if  attaching it here is not possible, I can contact you and figure out the next steps. Is this ok?

Thanks,

Cristian

[kari_rinne]

The issue occurs with all the panels in the walls. I attached the model. The view in the picture is SEINÄ 1. If the model seems bad, I am still just practicing Revit

[podaruc]

Thank you for attaching the model. We will investigate it, and will come with updates as soon as possible.

Cristian

[jay_colcombe · Accepted solution]

The issue appears to the the Top Left Panel and the small step in the bottom comer when trying to edit this part I get the following error

[jay_colcombe]

I did get a warning about edge reinforcement with the other panels but reloading the components fixed this so this would be related to the specification used

[kari_rinne]

I deleted the step that I didn't even notice previously (and wasn't supposed to be there) and now it works. Thank you very much!