Announcements

Starting in December, we will archive content from the community that is 10 years and older. This FAQ provides more information.

Part Material Thickness not correct when using Design to Fabrication in Revit

Anonymous

Part Material Thickness not correct when using Design to Fabrication in Revit

Anonymous
Not applicable

Hi, 

 

When I am converting ductwork in revit it is not showing the correct material thickness, it is showing 0.6 no matter what the size of the duct is, 0.6 is not in my database as far as I am aware. The specification is set to the service and the material and connectors are correct it is just the part material thickness which is wrong. I have attached an image of my specification setup in CADmep

0 Likes
Reply
280 Views
0 Replies
Replies (0)