Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I have found an obvious defect during the work with "Use Annot. Scale for Single Line Fittings". They work only at the floor plan. On 3d views, even they don't work at sections. In Russia as a part of the project documentation on engineering systems demand an axonometry. In Revit it can't be drawn and some are content with an isometry. Because of the fact that "Scale for Single Line Fittings" doesn't work to issue documentation extremely difficult. I ask to eliminate this defect.
Приветствую всех! Меня интересует вопрос, насчет инженерных возможностей. Почему в Ревите не появилась возможность привязывать траекторию коммуникаций? Допустим, проложен трубопровод на плане, а к следующему трубопроводу можно привязать траекторию уже проложенного трубопровода, лотка, кабеля и т.д. В основном, инженерные коммуникации(гофра, лоток, кабеля, трубы, воздуховоды) прокладываются одним направлением. Данная возможность может сильно упростить работу с инженерными коммуникациями.
