Wall Reveal - Structure

[Anonymous]

hello everybody,

i am trying to apply a reveal profile to a wall which has a 18cm+1,5cm structure.

i want the exterior layer (1,5cm) to follow the reveal-profile (2cm). is it possible or i should try modeling in place?

Thanks!!

 

[ToanDN]

I would use Cut Profile or filled region to fix large scale detail drawings only and leave small scale sections alone.

[Alan.johnson1970]

I would add the reveal in the wall and then add a 'model in place' sweep in the same place with the the shape you need at thickness of the layer and the same material.

Although I guess if you created a profile you could just add the sweep in the wall with the reveal.

or you could just add the detail as lines in your section.

[Karol_Piroska]

maybe you could try to add a sweep with same material at same location as the reveal?

[loboarch]

---

@ToanDN wrote:
I would use Cut Profile or filled region to fix large scale detail drawings only and leave small scale sections alone.

---

This would be the approach I would try to. Probably cause the least amount of problems in the long run, and would probably be the quickest solution too.

[barthbradley]

I'm kind of thinking along the same lines as most of you, except I might do it as a line-based family with an unattached void in it to cut the project wall ("Cut with Void when Loaded"). My two-cents worth.