Stairs Pattern Cannot Be Adjusted

[fitrananda.24116120]

I'm modeling stairs and trying to align the stairs pattern to an existing floor pattern. But there is 1 tread which I can't change. Whereas in other treads & risers it can be adjusted.

[barthbradley]

Paint with Model Surface Pattern and then align the Line Work of the Model Pattern.

Align the Surface Pattern on a Model Element | Revit 2019 | Autodesk Knowledge Network

...it looks like you have it highlighted in your screenshot. Are you saying it won't nudge using the Arrow Keys?  

[fitrananda.24116120]

that's the problem, it only can move up/down and cannot be left/right. that's why I cannot Align it to the next tread.

[barthbradley]

Have you tried Painting the Material/Pattern onto the Surface using the Paint Tool on the Modify Tab?  

[fitrananda.24116120]

Yes, I Have. but still. here I send the stairs model.

[barthbradley]

Hate to tell you, but it works on my end.   

Just to confirm: you are you using the Arrow Keys; right?  

[fitrananda.24116120]

I am using Align tools. that weird. even after I move that to a new file, I still cannot move it.

[fitrananda.24116120]

just to make sure, you change in 3D view, right? because, in-floor plan its pattern is okay, but not in 3D view

[barthbradley · Accepted solution]

Yes. In 3D. Aligning Tread and Riser Surface Patterns using Arrow Keys.  

[RDAOU]

@fitrananda.24116120 

Option 1: Use the Align tool and Align the Tread and Riser to the side/Edge of the Monolithic Run... See GIF BELOW

Option 2: Use Arrow Keys (Up/Down) as suggested by Barth

Option 3: Use Paint tool to apply Material with model pattern (More Flexible with Pattern alignment)

[fitrananda.24116120]

I Don't know I still cannot do so. but seeing that you can do it, then I think it's my software problem?

[fitrananda.24116120]

it's the first step that I cannot align. the other is in the right place

[ToanDN]

Restart Revit.

[fitrananda.24116120 · Accepted solution]

No, so I have found the problem. you must edit the stairs pattern when the section box is off. if section box is check, then the last step won't move