Revit não exibe topografia primitiva

[carolinarosa.arq]

Pessoal,

Bom dia.

Eu havia criado uma topografia primitiva e a alterado em meu projeto utilizando a ferramenta superfície com eixos. O calculo na tabela de topografia ficou perfeito. Entretanto em um dado momento o revit parou de exibir a topografia existente nas vistas, já tentei alterar o filtro de fase várias vezes e ela não reaparece.

A tabela de topografia continua fazendo o calculo corretamente, o que significa que a superfície original continua ali.

Alguém teria alguma ideia de como solucionar?

[barthbradley · Accepted solution]

The Existing Toposurface - the one you created a Graded Region Copy of - is Demolished.  In order to see it in a later Phase of construction View, you need to change the View Phase Filter to one that will show Demolished or remove the Phase Filter entirely from the View (e.g. set it to Show None).  

FWIW: if you are going forward with Phasing and preforming Cut/Fill calculations in each forward Phase, you need to establish a "new" existing toposurface condtion at the beginning of each of those Phases and create a  graded region copy from each new existing condition.   Get it?  

[carolinarosa.arq]

Thank you,

I tried to change Phase Filter no "None", and every Phase Filter, and still don't see the existing toposurface:

When i change Phase Filter to "Demolished" i see nothing.

I am working with just two phases "existing" and "new"

😞

[RDAOU · Accepted solution]

@carolinarosa.arq 

Show Complete???

BTW...in your schedule, the toposurface is for all created in New Construction...No existing topo will show in this one

Create a new schedule for Toposurface of the Existing Phase...if nothing shows there, then you do not have existing topography

[barthbradley]

---

@carolinarosa.arq wrote:

I tried to change Phase Filter no "None", and every Phase Filter, and still don't see the existing toposurface:

---

Sounds like you deleted it then.  You are welcome to post your file if you want to.  

[carolinarosa.arq]

In case that i deleted it, it would work if i copy the existing toposurface from my older file?

[mauricio_mssf · Accepted solution]

Não encontrei no arquivo, 

Você pode copiar de um arquivo anterior, copia e cola pela ferramenta de copiar no mesmo lugar.