PROBLEM WITH ADAPTIVE FAMILY

[malonicivil1]

Hello, good morning!

I have a problem introducing adaptive families created by 3 adaptive points along a line that I have previously graduated with points.

The problem is this: When trying to put the family along more than 3 points, putting it several times... I can't get families fitting together in curves, they overlap or there is a separation and I would like to know how I can unite families with each other or adapt to each other. Thanks a lot.

[barthbradley]

I don't understand the issue. Sounds like you want a sweep and not a repeater. Is that about the size of it?

...or is that not a repeater in your screenshot?  Maybe you should post the file instead.  Can you do that?     

[ToanDN]

Is the family supposed to be segmented or bent?

[malonicivil1]

hello,

What I want to do is a linear bridge work, placing an adaptive family by 3 points along the axis of the highway, the problem is that families do not fit together by putting several times along the axis

[malonicivil1]

preferably bent but is important that the families fit perfectly

[barthbradley]

---

@malonicivil1 wrote:

hello,

What I want to do is a linear bridge work, placing an adaptive family by 3 points along the axis of the highway, the problem is that families do not fit together by putting several times along the axis

---

Have you considered re-purposing ductwork for this job?  Food for thought.    

[malonicivil1]

Hello, I want to put the family along an axis, its not a profile its an adaptive family by three points I want be perpendicular to the axis in every point of the axis and fit perfectly the 1st family with the second, the 2nf family with the third one... tHANKS

[malonicivil1]

I have to model a tunnel with a complicated section