locker family not associating with host room

[jledgewood409]

i have a locker family and i would like to create a schedule that shows the lockers that are in each locker room (mens & womens.) i have created a furniture schedule and included these fields; room name, room number, family and type, mark, count, type mark. when the schedule is created the columns for room name & room number are blank. it seems as though my lockers are not associating with the room that they are located in. i have moved the room calculation point so that it is not on the ground plane and not in the center of the locker family and still no luck. i was hoping someone has a solution?

i am attaching the locker family for your review.

[bimscape]

All scheduling correctly here- using your locker family and 3 test Rooms.

Are you using Phases or Design Options?  Are you using Filters in your Schedule?

[jledgewood409]

no phases or design options for this project.

I do have a filter applied.

filter by: Type Mark contains L12X18

[bimscape]

What height do you have the Limit Offset at, for your Rooms?

[jledgewood409 · Accepted solution]

I have played with the limit heights with no avail. I tried something new. I copied the rooms and lockers in a new revit file and created a schedule. for some reason it populated in that schedule. so I did an "insert from file" and brought the working schedule into my project and the room names and numbers populate. go figure??

[Corsten.Au]

If you are not getting Room fied for the locker family, then just recreate locker family using " EXISTING FURNITURE "...

simple changing family parameter to Furniture may not work..

[jledgewood409 · Accepted solution]

so I found out that if I move the room calculation point and the fact that one of my rooms from the level below was bleeding into the room above I was able to make the adjustments and now the rooms populate on my schedule.