Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
We are facing one issue for Baffle adaptive component placing in one curved surface (adaptive mass). Mainly we need the end cut of the baffle like attached snap. Suggestion/Solution will be much appreciated.
Attachment Snap:
Requirement.png -- is our Requirement
Elevation view from our model.png -- which we have generated
We are facing one issue for Baffle adaptive component placing in one curved surface (adaptive mass). Mainly we need the end cut of the baffle like attached snap. Suggestion/Solution will be much appreciated.
Attachment Snap:
Requirement.png -- is our Requirement
Elevation view from our model.png -- which we have generated
I understood your question the first time...to have the component's normal follow the normal of the host. Change the orientation of the adaptive to XYZ Host (where Z is the normal) as mentioned in the previous reply. It is the purpose of an adaptive to adapt to certain conditions...in this case it is the curve hosting it
In the images I posted above, the cure ends tangent to the horizontal plane...
Adjust the curve not to be tangent to the horizontal plane and you wont have the straight cut.
Alternatively, use a custom end piece at the end of the curve
I understood your question the first time...to have the component's normal follow the normal of the host. Change the orientation of the adaptive to XYZ Host (where Z is the normal) as mentioned in the previous reply. It is the purpose of an adaptive to adapt to certain conditions...in this case it is the curve hosting it
In the images I posted above, the cure ends tangent to the horizontal plane...
Adjust the curve not to be tangent to the horizontal plane and you wont have the straight cut.
Alternatively, use a custom end piece at the end of the curve
