Curtain walls stands outside compared to normal walls.

[Anonymous]

Hello, I designed some places on my facade to be curtain wall and some places to be normal. At first, I drew them all as normal walls, then I changed some of them to storefront, but when I did that, the walls that were storefront started to appear outside the floor. How can I adjust them to fit exactly on the edge of the floor?

[barthbradley · Accepted solution]

Change the Panel's Type Properties?  

Offset Parameter:

Whatcha think?  That work? 

If all else fails, just make them really thick...

😁

[barthbradley]

...or, leave it as is and own the architectural design.  

[syman2000 · Accepted solution]

By default Storefront curtainwall always set to the center of the wall. So you need to customized to so it will be set to an edge. I've created a storefront that goes to the edge and you can check the glazing panel offset and the mullion offset for reference.