Border Tile : Partial leaves overhang

[parleyburnett]

I have a very simple case:

a surface (not rectangular  is divided into a grid pattern.  I have an adaptive curtain panel assigned to fill this pattern. 

why is there a 2" overhang of my curtain panel when my Border Tile setting is set to partial?  It trims perfectly on some but not on others. (See attached pic)

[enji.sorial]

But this solution only solves the geometry, but not the quantities. Is there a solution to the quantity problem? Kindly find the link to the file: https://wetransfer.com/downloads/8d82d29de4da47f3214465703e1cef3920190917050849/5d25fd496dc742cee0b3...

I also have another problem; that I have 3 pattern-based families with nested families (2 nested families each), so it doubles the quantity of the nested families despite the border.

For example: no. of Hexaplates  - Pattern-based 1= 288 whilst no. of hexaplates (Generic) = 576.

[martijn_pater]

Another idea is to make an in place geometry (solid) as SEO (Solid Element Operations) element and subtract (join/cut) this solid from your surfaced mass. Then assign this solid to a seperate subcategory (named SEO ie.) and turn that off in views/view templates.

Possibly then it would result in the correct geometry as well as volume? I haven't tested that yet, but this should then also work for curtain panels/mullions and or glazed roofing.

[enji.sorial]

Could you give an example on how to do it, I can't quite understand.

[martijn_pater]

See attached example / image.

[davidamar]

I agree. This issue has been going for way to long. Everytime I have this issue I spend time searching online for an answer hoping they have resolved it! Still nothing. Have they resolved in in 2020 version? If so I will use that instead of 2019. 

[atis.sed]

Revit 2021 and this still is an issue... But now we have schedules with alternating colors yay.............

[lestervidalgutierrez]

Comming from Revit 2024 and nothing yet. Still the same problem from over more than 12 years

[jack_coleMVS8P]

Insane they still haven't fixed this...