Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Submitted byAnonymouson11-20-201610:30 PM
Status:
Gathering Support
The display of the Weld lines.
Please make a functional enhancement so that after the angle of convergence more than 180 degrees, Weld lines are displayed. Refer to the attached file:Weldlines.pdf
Reason: The customer want to know the direction that Weld finally goes ahead through.
The definition in Moldflow: Where the converging flow fronts meet.: If it is less than 135° a weld line will form. If the angle is greater than 135° a meld line will form.
"Weld lines" result plot The "Weld lines" result plot is there by default After 135° weld line result disappears.
"Weld and meld lines" result plot The "Weld and meld lines" result plot is not there by default, and you need to create New plot... After 180° weld and meld line result disappears.
Could the "Weld and meld lines" result plot be useful for you in described case?