Populating default parameter with newly created parameter using iLogic

[eugene.morales]

I would like my parts template to contain the iLogic rule to populate the default parameter with the newly created parameter.

Default Parameter;

O_L = 1

O_W = 1

Newly Created Parameter;

d1 = 300 (may vary depending on part size)

d2 = 300 (may vary depending on part size)

The iLogic should read the default parameter if the newly created parameter is not created yet. Once it is created, it will automatically populate the default parameter.

I'm still a beginner using iLogic and I wanted to learn more how to create my own rule. Hopefully I could manage to create and share in this forum.

[bradeneuropeArthur]

Hi,

I don't understand what you try to do.

Isn't it easier to add these parameters to your template per default, instead of adding them with illogic?

Regards,

[clutsa · Accepted solution]

Are you looking for something like this?

For Each param In ThisApplication.ActiveDocument.ComponentDefinition.Parameters
	If param.Name = "d1" Then
		Parameter("O_L") = d1
	End If
	If param.Name = "d2" Then
		Parameter("O_W") = d2
	End If
Next

[eugene.morales]

Hi,

I've set a couple of custom parameter which is the O_L & O_W then if I create a plate with Length(d1) & Width(d2) parameter that is the time I will derive d1 & d2 to my custom parameter. Instead of manually deriving them I would like iLogic to automatically derive it for me. I hope it's clear as mud. ☺

[eugene.morales]

Thank you very much for your help.