When opening a part, the part is off the screen.

[ToddPig]

I have multiple parts (all similar to the attached) that when I open them, the screen is blank.  I have to "zoom to fit" to see the part.  This does not happen most of the time on other parts. 

What I have already tried:

1. Checked each sketch for geometry that might be "out-in-space"

2. Checked each block for geometry that might be "out-in-space"

3. Zoomed in, then save, close, and reopen.

4. Restarted Inventor

For Reference:

The thumbnail image in Vault shows the part.

I saved the part as an IGES file and opened it in SW.  Upon opening, it zoomed to fit the screen.  When I closed and reopened, it again was full screen.

Thanks in advance

Todd

[hugo.trepanier · Accepted solution]

Hi,

Just change these 2 values in the document settings. enter 0 and 0 and save. All will be ok after

[JDMather · Accepted solution]

You can also set the view however you would like it to be and then right click on the View Cube and Set Current View as Home Position.

[ToddPig]

@JDMather - As always, Thanks!!

Any idea how I can prevent this from happening?

[ToddPig]

@hugo.trepanier - Thanks.

[kschumacher]

Isn't there a setting somewhere in Application Option so it works "globally" ?

Seems I recall doing it before but it was eons ago.

Thanks,

Ken -