Announcements

Starting in December, we will archive content from the community that is 10 years and older. This FAQ provides more information.

Spline not precise in Inventor DWG

Anonymous

Spline not precise in Inventor DWG

Anonymous
Not applicable

i seem to have run into a problem with inventor 2017 DWGs. i revolved a part made up of a spline and created a Dwg so that i could bring the part into AutoCAD. I noticed that the bottom of the part was not matching the profile of the roll, but it would match if i change the view to Raster. The height of the misalignment is about 1" tall. Unfortunately, i cannot use a raster view in AutoCAD, but i have found a workaround by exporting the sketch of the profile to a DWG and working form there. 

 

i recently updated Inventor to 2017.3. I am not sure if this could be something new due to this update.

0 Likes
Reply
441 Views
3 Replies
Replies (3)

blair
Mentor
Mentor

Possible the setting to use "Offline Only" in the Document Setting>Drawings>Shaded Views: was changed from "Offline Only"


Inventor 2020, In-Cad, Simulation Mechanical

Just insert the picture rather than attaching it as a file
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
Delta Tau Chi ΔΤΧ

0 Likes

Anonymous
Not applicable

that doesn't seem to have done anything. Creating a section view down the middle of the parts works as well. 

0 Likes

inchul.lee
Autodesk Support
Autodesk Support

Hi @Anonymous

 

Could you please share your files so that we can review them?

 

So, it sounds like your ultimate goal is to reuse the Inventor drawing in AutoCAD. What happens if you save the drawing as AutoCAD DWG? Did you try to add "REPLACE SPLINE=No" in the export configuration file (.INI)?

 







Inchul Lee
0 Likes