This is a trial. I want to model a cylinder with 6 slightly twisted (5 degree) tooth. In the process I decided to make 3 similar sketches in 3 parallel planes with 5 degree turned and use loft command to make it.
But when I tried to rotate green colour sketch through 5 degree error message is coming. How to fix it?
As @PaulMunford mentioned ... Sweep with a twist...
If this would work ..then give him the kudo's/solution ...
Tooth are coming in a straight line, whether it is possible to make it come in a curved line like in this image.
yes ..that's possible ...
but that's a different type of gear
you'll need to change the design you're using...
are you doing this tutorial?
https://www.youtube.com/watch?v=2erIPXUKdI8
what version of inventor are you using again?
here you can see more of the twist at different angles....
of you gear you'll need the back side larger ...so a loft would be best if that's the gear you want ...
The one you started and end with the same sketch, just rotated, so that's what Paul and I were showing you.
