Embossing on Taper curved Face

[Anonymous]

Hi,

Do we have embossing feature on taper curved face?

We are getting below while trying to do this.

Thanks for your response in advance.

Regards

Abhiranjan Sudhanshu

ak.sudhanshu@integratedww.com

[Anonymous]

Yes, but your workplane has to be parallel to that face.

If you can't figure it out you could attach your file here.

[Frank-Oosterwaal]

Hi,

It looks like you selected "wrap to face".

Deselect it and make sure the emboss is in the right direction.

It should work after that.

Good luck!

[Anonymous]

It should be Wrap to Face as per requirement.

[Frank-Oosterwaal]

Hi,

Ok, in that case do what @Anonymous said.

1. Create a plane parallel to the face the emboss has to go to

2. Sketch the name on that plane and emboss with wrap to face.

Good luck!

[Anonymous]

I did tried that too. I made a tangent Plane with face and then had text on that plane.

https://drive.google.com/open?id=0B04OHOZH8av4cG5GVFhHNG5MdGc

[Anonymous]

Still, there is an issue. Additionally, I am not getting correct orientation of Text. Text is coming as mirrored text.

[Anonymous]

See attached file.

The problem with the orientation is that you are sketching on the wrong side of the plane.

The problem with the embossing, I think, is because of your workplane is laying within the part. It wasn't tangent to the face.

[Anonymous]

I am using Product Design Suite Utlimate 2015

[Anonymous]

Ok sorry wait a sec

[Anonymous]

Thanks Tniens, But I have Lower version (2015) at my end, so can't open your file.

[Anonymous · Accepted solution]

Here you go

Create a workplane. Workplane > Click the intersection point from that sketch and edge of the part > Click the tapered face

Next create a sketch on the workplane and type your text. 

Last Emboss!!! 

[Anonymous]

I tried by playing the location of plane. 1st I took on the tangent edge, then Outside of part as parallel plane to the tangent edge and then inside the part (Parrallel)

[Anonymous]

Try to do it like in my previous post

[Anonymous]

I am done now. I have fixed the text oientation by using Geometry Text.

I have kept the plane tangent to the tapered Face.

Thanks to all for your kind support.

[SBix26 · Accepted solution]

The fix for your text orientation issue is simply to reverse the workplane normal: right click on the workplane and choose Flip Normal.  Now the sketch is on the correct side of the plane so your text reads properly.

Sam B

Inventor Professional 2016 R3 SP2
Vault Basic 2016 SP1
Windows 7 Enterprise 64-bit, SP1

[Anonymous]

This options works too.

Thanks