3D spiral for a sketch driven pattern

[frank.ovstetun]

Hello,

I am trying to make a brush in inventor and I am having trouble setting a brush on a brushcore on a spiral that I made as a reference. Is there a way to make it without creating 3 reference planes for each brush?

I am attaching the original brush that I made in SW (Børste 2 spiral) and the one I am trying to make now (Børste 3) in Inventor.

This is the brush that I made in SW that I want to remake in Inventor with different dimensions (same core diameter, total diameter 100mm, lenght 300mm)

I want to have brushes across the whole lenght of brushcore on the reference helix that I made

Thanks

[frank.ovstetun]

Hello,

I am trying to make a brush in inventor and I am having trouble setting a brush on a brushcore on a spiral that I made as a reference. Is there a way to make it without creating 3 reference planes for each brush?

I am attaching the original brush that I made in SW (Børste 2 spiral) and the one I am trying to make now (Børste 3) in Inventor.

This is the brush that I made in SW that I want to remake in Inventor with different dimensions (same core diameter, total diameter 100mm, lenght 300mm)

I want to have brushes across the whole lenght of brushcore on the reference helix that I made

Thanks

[-niels- · Accepted solution]

I'm on IV2021 so i couldn't see what you did, but is there a reason why you're not using a rectangular pattern?

[-niels- · Accepted solution]

I'm on IV2021 so i couldn't see what you did, but is there a reason why you're not using a rectangular pattern?

[frank.ovstetun]

Hey,

Thanks for the reply. I didnt think that rectangular pattern would be applicable in this case.

This works well, thank you!

[frank.ovstetun]

Hey,

Thanks for the reply. I didnt think that rectangular pattern would be applicable in this case.

This works well, thank you!