Solved! Go to Solution.
Solved by skidsolo. Go to Solution.
Laurens Wijnschenk
3DTechDraw
AutoDesk CAM user & Post editor.
René for Legend.
Hello.
I have problem, mashine is DeckelMaho DMU 50v, B-axis table rotate under 45 degrees. Control is MillPlus v330, without G07 g-code.
Can You help me to solve this problem.
Thanks
Hello
I'm also looking for a processor post for DMU 50 - 5ax continuous with sinumerik 840 D (CELOS)
Who can help me ???
Thanks
emaill: marius_micromet@yahoo.com
@marius_micromet wrote:
Hello I'm also looking for a processor post for DMU 50 - 5ax continuous with sinumerik 840 D (CELOS) Who can help me ??? Thanks
emaill: marius_micromet@yahoo.com
The generic Siemens 840 D should just run if you setup the machine configuration properly.
https://cam.autodesk.com/hsmposts?p=siemens-840d
Laurens Wijnschenk
3DTechDraw
AutoDesk CAM user & Post editor.
René for Legend.
Can't find what you're looking for? Ask the community or share your knowledge.