MecaNumeric Pro 4020 and MultiCut 3000 post processor request

[Anonymous]

Hello everyone! 

I have a problem with post processors. 

We have 2 CNC milling machines: MecaNumeric Pro 4020 and MultiCut 3000 with working surface 3050х2050. 

We want to move from using ArtCam 2012 to Fusion 360

We use post processors in ArtCam 2012:

1. mecanumeric.opt for MecaNumeric Pro 4020

2. gcode_mm.con for MultiCut 3000

post processors are here: https://yadi.sk/d/8bqEHRVeN62PlA

I cannot find suitable post processors for the Fusion 360. Also I can not load the current post processors that i used in ArtCam 2012.

Can anyone suggest a suitable post processor for these machines? Or send a post processor? Or advise who to contact?

Best regards, Georgy

[Anonymous]

Update: 

Control system for MultiCut 3000 is WEIHONG NK 105

[Anonymous]

Update
Post processor for MultiCut 3000 found. Everything works fine.

But i can't find post for Meca. Our Meca Numeric Pro 4020 is already 15 years old. Control system - CN5000.

Help me find the post processor for MecaNumeric POWER AUTOMATION CN5000 please

[serge.quiblier]

Hello @Anonymous 

We have updated our PowerAutomation post.

The Mecanumeric is using this brand of controller.

If your are willing to test it :

https://cam.autodesk.com/hsmposts?p=power_automation

I am warning you that the post output had not been tested on a machine, it's a generic PowerAutomation post.

The Mecanumeric may require some machine builder specific codes.

So use it with care, and don't hesitate to provide feedback

Regards

[Anonymous]

hi friend im looking for cn5000 post processor too 

have you find it?

thanks a lot is very important and hurry for me please