Hello everyone!
I have a problem with post processors.
We have 2 CNC milling machines: MecaNumeric Pro 4020 and MultiCut 3000 with working surface 3050х2050.
We want to move from using ArtCam 2012 to Fusion 360
We use post processors in ArtCam 2012:
1. mecanumeric.opt for MecaNumeric Pro 4020
2. gcode_mm.con for MultiCut 3000
post processors are here: https://yadi.sk/d/8bqEHRVeN62PlA
I cannot find suitable post processors for the Fusion 360. Also I can not load the current post processors that i used in ArtCam 2012.
Can anyone suggest a suitable post processor for these machines? Or send a post processor? Or advise who to contact?
Best regards, Georgy
Update
Post processor for MultiCut 3000 found. Everything works fine.
But i can't find post for Meca. Our Meca Numeric Pro 4020 is already 15 years old. Control system - CN5000.
Help me find the post processor for MecaNumeric POWER AUTOMATION CN5000 please
Hello @Anonymous
We have updated our PowerAutomation post.
The Mecanumeric is using this brand of controller.
If your are willing to test it :
https://cam.autodesk.com/hsmposts?p=power_automation
I am warning you that the post output had not been tested on a machine, it's a generic PowerAutomation post.
The Mecanumeric may require some machine builder specific codes.
So use it with care, and don't hesitate to provide feedback
Regards
hi friend im looking for cn5000 post processor too
have you find it?
thanks a lot is very important and hurry for me please
Can't find what you're looking for? Ask the community or share your knowledge.