Bug when using rectangular pattern on hole

[ryan_thaler]

im trying to create a hole pattern and for some reason, im getting a small bug. I made the hole and used a rectangular pattern, shown below, and for whatever reason, the holes on the right side show a surface above where the hole is. Ive tried selecting optimized, identical and adjust with no success. Am i missing something? thanks

[jeff_strater]

Hard to say what I'm looking at in those images.  Can you share the model here?  (export as F3d and attach it to your next post)

[TheCADWhisperer]

@ryan_thaler 

Do you have the correct component active?

Attach your file here and end all doubt.

[ryan_thaler]

@TheCADWhisperer @jeff_strater i closed the file and tried opening it again. now the left side had the bug. i did that again and there's no issue. so i think it's just a compensation for rendering. this is part of a rather large assembly so makes sense.

[g-andresen]

Hi,

Please share the file then we can analyze the situation.

File > export > save as f3d on local drive  > attach it to the post.

günther