Message 1 of 6

Not applicable
12-29-2019
10:21 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
I'm trying to place an SVG (a logo) on a flat surface and control its position on that surface via a parameter. I would like the corner of the sketch to be positioned at a point relative to the side of the surface
In the attached image, the origin of both sketches is the same as the design origin. I want the four shapes (Sketch 1) to stay in the same position relative to each other but move relative to the rectangle (Sketch 2). If I could drive the origin of the Sketch 1 based on geometry that would work. If I try to drive the contents of the sketch they move separately and I can't figure out how to make them move together.
Solved! Go to Solution.