VERY new to F360 ( and design in general ) and am about to pull my hair out.
I am trying to model a very simple makeup case cover for my daughter. It is a very basic rectangle with rounded corners. However:
The corners at the bottom of the rectangle are much more rounded than the corners at the top. It is actually this cheap case:
I have been searching for about 30 minutes now just create a rounded corner and am utterly lost. Any help would be much appreciated!
Solved! Go to Solution.
Solved by jeff_strater. Go to Solution.
The message was directed at you, the bully, not at Claas and was in response to my request to shut this thread down. Unfortunately that did not happen!
Might be a moment to step in.
Claas Kuhnen
Faculty Industrial Design – Wayne State Universit
Chair Interior Design – Wayne State University
Owner studioKuhnen – product : interface : design
Well, I don't think anyone reading this thread, from the beginning, would see anything other than what I stated. I made my case. I am done with this bickering.
Jim
Can't find what you're looking for? Ask the community or share your knowledge.