Project Sketch not updating timeline

[nkloski]

Hmmm......I just tried this out on a new model and it worked fine, but the model I have been working on does NOT work like this brand new model.

I have a Form that I am projecting some sketched circles onto.  I then "split body" the projected circles, and then "delete" the bodies in order to make some circular-ish cuts.  On the new file I can go back to the sketch and edit the circles into new places, and the changes travel down the timeline just fine.  But in the model I have been working on the changes do not travel down at all....the initial sketch is changed, but the resulting holes are where they always were.

I tried to "compute all" but that did not have any effect....anyone know why those changes would not propagate?

Thanks,

Nick

[jeff_strater]

Hi Nick,

without seeing the model it is hard to say. It could be a bug.

The only thing offhand I can think of is if your older design is not a "history-based" design. Do you see a timeline at the bottom of the older design?

If you can share or post your design, we'd be happy to take a look.

Thanks

Jeff Strater (Fusion development)

[nkloski]

Thanks!  I will attach the file here, but PM you the password to open it, since it is a client design I am working on......Thanks!

[nkloski · Accepted solution]

Just for clarification for other in the future, this was found to be an "interesting" bug.  Submitted for analysis, even though I have never seen it again, nor would maybe anyone else.