Placing Holes on another Plane

[jbranch9814]

I am trying to add two .280 dia. circles on the intersections of these highlighted lines, but I can't for the life of me figure it out. I've tried re-associating the sketch plane, rotating the whole piece, and I can't get the circle to snap to the intersections. Any ideas/ help? Attached is the file. Love the software, and this community!

[TheCADWhisperer]

Is there a reason you are doing this as single wireframe 3D sketch rather than as simple 2D sketch and Extruded solid body?

[jeevesme · Accepted solution]

It appears that you created this sketch using 3d sketching, is that correct?  3d sketching in fusion is a PITA.  It's an infant compared to Sketchup. Try to avoid it if you can. That being said, you could just create a new sketch on the same plane that you want the intersecting circle to go.