Not all digits of value showing while dragging size in sketch

[janus2]

First digit not showing

Hello!

If i drag a circle for example I can not see all digits. Should display '11.23'. The first '1' is not visible. I tried to remove the 'millimeter' text in preferences without success.

I think the display box is too small.

Do I have a chance to improve here or do I have to wait for Autodesk.

Jan

[HughesTooling · Accepted solution]

Go to preferences and check Display abbreviations for units. Note you'll need to close and reopen the sketch to see the change.

[janus2]

Thanks a lot. That was the trick!

Jan

[chrisplyler]

Also, just in case you don't already know this (unlikely, but  just in case), you can just type the exact value you want into the field.