Message 1 of 17

Not applicable
01-06-2017
04:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
This is probably a dumb question, but I'm just getting my bearings in Fusion 360 and can't figure out how to move objects in a sketch to a specific point. For example, if I click the center of a circle I can move it around with the mouse and with the move command I can give it relative points to move it a certain distance away from where it is, but I cannot figure out how to, say, move the center to x=5 and y=10. How can I specify a specific point to move an object to?
Solved! Go to Solution.