mirror error

[Anonymous]

The assumption of the  mirror function it should let to copy also faces. Then ,why the attempt of the using mirror funcion with faces  usually does generate error ?. I tried it many times.

[ADSKDJW4]

Hello ludwika85,

I have tried some simple designs to where it appears the mirror faces would need to be mirrored and the result of the new faces would need to be on the body of the original model. I am also seeing these errors when mirroring faces and cannot come up with an example to show you a mirrored mace. Can you attach a sample model to where you need to do this and I can log this issue to the development team.

Best Regards,

Don Warner

[Anonymous]

Hi

The model is attached  below as *.igs file

[ADSKDJW4]

Hello ludwika85,

I have downloaded the Iges file. Can you tell me exactly what you’re trying to mirror? Possibly show me in a couple of screen shots, attach to a post reply? I would like to see if I can get you an answer on this.

Best Regards,

Don Warner

[Anonymous]

Hi Don

The YT presentation is attached. https://youtu.be/66nXHH_C_XA

Some for explain :

System : WIN 8,1 64bit polish version

In polish "Brak odpowiedzi" means "Not response"

After "OK"  in the mirror window AF360 is crashes for ever . The Task Menager helps only.

Sorry, but remember in Eurpe we have now 9.30 PM time.

 Best Regards

[bob_holland]

ludwika85,

With your IGES file we only get one body in Fusion.

All I see there is a face.

Can you please share your model with me.

bob dot holland at autodesk dot com.

Thank you.

[Anonymous]

Hi Bob

You have shared the whole project .You can find this model in the folder which is named "router_plane"

Regards

[bob_holland]

ludwika85,

I went back to your source IGES file and I am experiencing the same issue.

I will be asking our development staff to take a look at this.

Thank you.

[bob_holland]

@ludwika85,

I played with this a little more and found that if I do a 0 offset of the face and turn it into a body, it sill allow me to mirror the body.

I have attached a screencast of the operation.

FYI

[Anonymous]

Sorry , but where is this screencast. Did you attached it to the post ? I can't find it.

[bob_holland · Accepted solution]

ludwika85,

I am sorry that the attachment was stripped out.

I will embed it:

[Anonymous]

Thanks Bob. A little complicated, but it is a good solution, the more the new face could stand alone, basic face (after offset) could be erased