
Hi!
I am a newcomer to Fusion 360, and I am currently trying to model a pressure-swirl injector in it in order to use it on CFD analysis.
The problem is that I need the volume through which the fluid particles will travel, since this is the geometry the CFD software requires for meshing. But to this moment I have not been able to get this geometry, mainly because of the tangential inlet slots (which are shown in the image attached). I have tried using Patch to cover the hole and further using Boundary Fill, but I haven't had success.
I need these slots (holes) to be filled (along with the injector swirl chamber), but I cannot find a way to solve this. If anyone could help, I would really appreciate!
Best regards
PS: I attached both an image of the injector and the injector file.
已解决! 转到解答。