3D box design in fusion 360

[Anonymous]

I am new to AD and I am making a box for my circuits. The box is ready and I have to create holes for the screws with required dimensions. I have a Picture of mechanical specification of the circuit board, I am Uploading the image. In that I dont know what is 3 X4 mean? Can someone explain?

[TheCADWhisperer · Accepted solution]

Center is 3mm from edge in 4 locations.  The hole diameter is 3mm.

Given the width and height of the board - the source obviously is lost.

File>Export and then Attach your *.f3d file here if you can't figure it out.

[Anonymous]

Thank you!!

Well, My Question is you have attached a photo in Autodesk 360 and when I see the properties the dimensions also match!! I mean WOW!! I have around 4 Circuit boards and I can put them and drill it for screws..

I didn't understand following..

"Given the width and height of the board - the source obviously is lost"

[TheCADWhisperer]

---

@Anonymouswrote: 

I didn't understand following.. 

"Given the width and height of the board - the source obviously is lost"

---

Is the board 6.98mm x 3.8mm as indicated on the original image or is it really 69.8mm x 3.8mm?

Units?

[Anonymous]

""Is the board 6.98mm x 3.8mm as indicated on the original image or is it really 69.8mm x 3.8mm?""

Yes it is really 69.8mm x 3.8mm. And the Autodesk 360 also has correct dimentions..I measured it!!