Stretch and move plus stretch and move.

[Tee.Dee]

Sorry for the title not sure how best to name what i'm trying to do.

.dwg attached which is a representation of my actual block.

What I would like to do is have a single grip which moves the green, yellow and red squares a certain distance and stretches the branches of each, so far I've managed to achieve this much.

This is where i'm having trouble, What I would also like to do is once the green and yellow reach their maximum positions I would like the red square to keep on moving until it reaches the blue line to the far right.

Thanks!

[Libbya]

See step-by-step screencast in followup post.

[Tee.Dee]

Thanks Libbya!

Now to get my head around look up tables.

And sorry for the new thread, only reason I did this was because the original obviously wasn't getting much attention probably due to the bad title hence recreating it with something more relevant 🙂

[mehrdad.rahimi.en65]

Hi dear friend, you have two types of tools in your pallet that I had never seen before. How can thriple lookup and double lookup be created? The solution you provided cannot be implemented without double lookup.

[vinodkl]

Hi,

See this :How to Make a Double Lookup 

[mehrdad.rahimi.en65]

Thank you, actually I had made one(Double Lookup) but I didn't know (BACTIONBARMODE) and didn't use it. It is so good.

Now Please explain about the numerical structure you entered in Distance field in Lookup1. And if we want to do this for a three-piece telescope piece, how do we enter the field Distance value?

[Libbya]

https://knowledge.autodesk.com/support/autocad/learn-explore/caas/CloudHelp/cloudhelp/2018/ENU/AutoC...

That list is mostly correct, but is wrong where it says that (,5) is a value greater than 5 and (5,) is a value less than 5.  Those should be reversed.

[mehrdad.rahimi.en65]

thank you dear friend. it is what exactly that i'm looking for.