Interior Elevation Tag

[Anonymous]

Here we go again . . .

I have attached the interior elevation tag we use in our office.  What I am trying to achieve is the ability to have the solid poche be on/off for each "arrow" independently.  I would like to be able to have full control over the on/off state though where I can have any combination of the arrows on/off at the same time.  

Also, looking to Libbya here, how would I add the same scale via LookUp ala the north arrow tag you helped me with last week.

Thanks again!!!

[Libbya · Accepted solution]

I don't have time to explain more now and will be away for a bit.

The scale is the same solution as before.  

For the multi-visibility I used the solution I posted in this thread:  http://forums.autodesk.com/t5/dynamic-blocks/ootb-multiple-visibility-states-solution/m-p/4961288#M1...

I would prefer the function of the second block where I used Flip parameters as inputs as you just have to click the grip.  

[Anonymous]

Lbbya,

Thank you again.  I am learning alot from your expertise in AutoCad!  I have applied what you did for the Elevation Tag to a Partition Type tag we used.  The tag works beautifully, but I cannot get rid of the "custom" field in the LookUp.  Obivously my eyes are looking over something that is triggering this.  When you have a free moment ( I say that with a chuckle because your free moments appear to be on this board helping all of us) can you have a quick look at this block?  Hopefully you will see what I have overlooked.

Thanks!

[ojuris]

You had empty lookup table "Lookup5" for Lookup1 parameter

Regards

Juris

[Anonymous]

Thank you.   I need to start working on these blocks using BACTIONBARMODE = 0.  I would have caught that then and I didn't even think to check!

[Anonymous]

Hi,

Dear I need a Dynamic Tag for numbering 

in project drawings all time we need to make tag for equipments or pipes ....items reference point on site ext..

i need dynamic tag help us as per attached autocad drawing

[jrr]

Hi Libbya,

Do you have a tag like this that would be for only one interior elevation but can use four different visibility views?

Thanks.

[Libbya]

I'm not sure what you are asking for.  If you want only one arrow, there is no need for visibility states.  Just add a rotate to the arrow to allow it to point whichever direction you like.  

[Anonymous]

Hi

How do you change the hatch color from pink?

[Libbya]

As stated above, it uses different visibility states and uses different lookups or the flip parameters as inputs to a double lookup to do the switching.