Dynamic Shelf Block With Array Of Dynamic Holes

[paul9ZMBV]

Hi 

I have a dynamic block with a shelf drawn,

The dynamic block can be adjusted for width and for the thickness of the shelf.

Could someone kindly add a dynamic array to the block that i can pull the adjustable holes up or down (32mm apart)

So the shelf could either have just the 2 holes supporting it or say another 4 pairs of holes above and another 3 pairs underneath (for example)

I just cant figure out how to add the array in the dynamic block.

TIA

[j.palmeL29YX]

Is that what you're looking for? 

[paul9ZMBV]

Thanks for the help.

The shelf thickness needs to stay constant (unless the shelf is stretched in thickness)

The shelf stud holes (5mm holes) need to be able to stretch up as an array and down as an array separately so that the hole directly under the shelf is on the top of the hole. 

If that makes sense

 

[j.palmeL29YX]

Test the attached  ...pa1

[paul9ZMBV]

very very close,

just one small error the shelf ends don't follow when thickness stretched

Your help is much appreciated with this

 

ch

[j.palmeL29YX · Accepted solution]

---

@paul9ZMBV wrote:

just one small error the shelf ends don't follow when thickness stretched

---

Oh sorry, I forgot to include the both vertical lines into the selection set of the stretch action. 

Attached the repaired block (name not changed). 

[paul9ZMBV]

Thank you very much for your help with this its much appreciated