Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Allow both pipes and structures to be shown in the same table
Allow pipe networks tables to show both pipes and structures in the same table.
I use pipe networks for utilities and a requirement by our clients for plans is to show the station offset from the reference alignment for both structures (utility pedestals) and the pipe (conduit) in station order. I would like to show both in one dynamic table. Right now I have to create one pipe table and one structure table and then combine them manually in excel.
Did you ever figure anything out on this? I want to be able to list a pipe culvert and the two end sections in an install note, with the station callout being at the ends of the end sections, not the ends of the pipe.
