varying slope assembly

[Anonymous]

hello

here is the pkt zip file

please help me correct that wrong pkt file

thank you so much

i want that kind of varying slope assembly.but i also have only one surface layer.

so i have to try subassembly composer but i dun know about programming and now i am in trouble

[KMercier_C3D]

Can you answer some questions about your subassembly?

1. Can you explain how the 72.0 is determined in your image? 
2. Would the attachment point be at the bottom left corner (next to the 1700 in the image) or at the upper left corner (next to the 76.2 in the image)?
3. Where is the target surface in your image? Up above the 1:1.2? What happens if the target surface is in different locations?

[Anonymous]

sorry my reply was late

i was wrong. i created a subassembly composer but the link is the problem. the gaps are found

please check my pkt file.

thank u so much 🙂

[KMercier_C3D]

For that pkt file, are your codes behaving properly? I would try putting a comma between every code for all points and links. 

[Anonymous]

thank u so much for your reply

yes. the problem is the codes points and links

to create polyline from corridor,i have to click the outside of the corridor in one click but it was not able to click.

may be the way i talk is hard to understand.

the corridor (Daylight Bench) was able to be turned into one polyline

but the corridor i created was not able to be turned into one polyline

please tell me the problem.

thank u so much

i attached the picture.

[Anonymous]

here is the attached file

[KMercier_C3D]

In your Corridor Properties, on the Feature Lines tab, what options do you currently have selected for Branching, and do you have the "Connect extra points" selected?

[Anonymous]

thank you very much for your reply

as u told,i made the feature line settings

but the one thing is that the outside of the corridor was not able to be connected.

i want to make it connected. may be the problem is the subassembly code settings or desicion formula?

please let me know.

thank you very much.

i attached the file data.

[KMercier_C3D]

In SAC, do you have a point code that is consistent at the daylight point for all of your Decisions branches? 

[Anonymous]

thank you  so much for ur reply

i do not understand what you want to mean