Adding a range to a cut/fill banding surface

[civilman1957]

Good morning, all...

I've created a cut/fill banding surface in order to see areas of extreme elevation change in our design drawing. Unfortunately, I didn't take my ranges high enough to account for the most fill needed. I only made them to a max if 3 feet of fill, and I need four. Anyone know if I can add a range to my surface without starting over again?

[Joe-Bouza]

go back to the analysis tab and re do with 4 ranges

[civilman1957]

Yep, I know I can do that...I just was hoping I could "append" my ranges and not start all over again....

[SteveLDucharme]

One of THE most frustrating issues with the use of banding especially when using volume surfaces which change often. It's astounding to me that after about a decade of using this tool there is still no way to save banding styles/ color settings/ranges. I can't imagine it's a major challenge for the developers. We use a LOT of it and I think my hands are now able to almost automatically type in the color schema and increments almost without looking.

[civilman1957]

I'll go along with that. I don't mind re-doing it, but for whatever reason, my cad runs super slow while assigning range values. I have rebuild off and so on, but it still takes forever...